Help Center
New to VisionScaper?
Start here
Help Center › Admin screens, field by field › Marketing settings: Costs and limits
Marketing settings: Costs and limits
The cost per text, cost per email and messages-per-run fields, plus the Save buttons on the Marketing page.
On this page
On Settings → VisionScaper Marketing, Costs & limits sets the numbers used for campaign ROI and how fast mail goes out. A note below the form says marketing allowances (campaigns, automations, emails and texts per month) are edited under Settings → VisionScaper Plans & billing.
Fields
Defaults are placeholders, not approved; set your own.
| Field (exact label) | What it does for VisionScaper | What to enter and example | Default / notes |
|---|---|---|---|
Cost per text segment m[sms_cost] |
Used for each campaign’s ROI. Kept between 0 and 1 dollar. | Dollars, for example 0.0123. | 0.0123 |
Cost per email m[email_cost] |
Used for each campaign’s ROI. Between 0 and 1 dollar. | 0.0015 | 0.0015 |
Messages per 5-minute run m[tick_max] |
Most messages sent each run, all contractors together. Between 10 and 1000. Big campaigns go out over several runs. | 80 | 80 |
Buttons
- Save: stores every field on the page.
- Save & send me a test email: saves, then emails the logged-in administrator a test. The message says which service sent it.
Steps
- Enter your real per-message costs.
- Set messages per run. Lower is gentler on sending reputation.
- Press Save. A blue notice shows the result.
If something goes wrong
- Values reset to limits: numbers outside the ranges are pulled back in.
- Campaigns go slowly: raise Messages per 5-minute run, and make sure scheduled sending runs regularly (see the Health box).